Mounting Plate - Cisco Aironet 1130AG Series Hardware Installation Manual

Chapter 2 Installing the Access Point

Mounting Plate

The access point mounting plate is designed to accomodate multiple mounting methods. The mounting
holes on the plate are marked so you can easily identify the correct holes for a specific mounting method.
You can use the mounting plate as a template to mark the locations for the cable hole and the mounting
holes for your wall or ceiling installation. Refer to
the method you intend to use.
Figure 2-2
1
2
3
The mounting plate features are described below:
•
•
•
•
OL-6226-01
C I S C O C O N F I D E N T I A L -
Mounting Plate
Keyhole clip
Screw holes (A, B, C)
Location for cable access hole
Keyhole clips—used to attach the access point to the mounting plate. The keyhole clips slide into
the access point keyhole slots on the bottom of the unit.
Screw holes (A, B, C)—used to attach to the suspended ceiling adjustable T-rail clips.
Screw hole (X)—used to attach to a network cable box, wall, or ceiling. The mounting kit contains
two 8x32x1 inch pan head screws and wall anchors for wall or ceiling mounting.
Security screw hole—used to secure the access point to the mounting plate.
You can use a special security screw to restrict the removal of the access point from the
Note
mounting plate.
D r a f t 2
Figure 2-2
4 Screw hole (X)
5
Security screw hole
6
Padlock hole
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Before Beginning the Installation
to locate the various mounting holes for
2-5