Checking The Autonomous Access Point Leds - Cisco AIR-AP1252AG-A-K9 Hardware Installation Manual

Chapter 3 Troubleshooting 1250 Series Autonomous Access Points

Checking the Autonomous Access Point LEDs

Checking the Autonomous Access Point LEDs

If your access point is not working properly, check the Status, Ethernet, and Radio LEDs on the top of
the unit. You can use the LED indications to quickly assess the unit's status. Figure 3-1 shows the access
point LEDs (for additional information refer to the Event Log using the access point browser interface).
Figure 3-1 Access Point LEDs
ETHERNET STATUS RADIO
ETHERNET STATUS RADIO
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
3-2
OL-8247-03