Issuing The Cisco Ios Command Using The Cli; Configuring The Access Point System Power Settings Using A Browser - Cisco AIR-AP1252AG-A-K9 Hardware Installation Manual

Chapter 3 Troubleshooting 1250 Series Autonomous Access Points

Issuing the Cisco IOS Command Using the CLI

Follow these steps to issue the Cisco IOS command for your power scenario:
Step 1 Connect a PC to the access point console port and use a terminal emulator to establish a session with the
access point (refer to the
Step 2 From the global configuration mode (refer to the Cisco IOS Software Configuration Guide for Cisco
Aironet Access Points), enter the command below that applies to your power configuration (see
and
•
•
•
•
Step 3 Enter the write memory command to save the setting to the access point memory.
Enter the quit command to exit the terminal session.
Step 4

Configuring the Access Point System Power Settings Using a Browser

You can also use your browser to set the access point system power settings.
When using the access point browser interface, you should disable your browser pop-up blocker.
Note
Figure 3-3
series power injector detected).
Figure 3-3
OL-8247-03
"Connecting to the Access Point Locally" section on page
Table 3-4):
power inline negotiation injector installed (not required)
no power inline negotiation injector (not required)
power inline negotiation prestandard source
no power inline negotiation prestandard source
shows the system power setting options and indicates the access point power status (1250
System Power Settings
Low Power Condition on Autonomous Access Points
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
3-22).
Table 3-3
3-13