Installing Option Two - Cisco AIR-AP1252AG-A-K9 Hardware Installation Manual

Chapter 2 Installing the Access Point
Prior to attaching the access point to the mounting plate, ensure that the radio modules are completely
Step 12
inserted and both module latches are in the locked position (see
Step 13 Attach the access point to the mounting plate (see the
on page
Step 14 Connect the antennas or antenna cables to the access point connectors and hand-tighten. Ensure the
2.4-GHz antennas or antenna cables are connected to the access point's 2.4-GHz antenna connectors (see
Figure 1-1 on page
Note
If you need additional security, see the
Step 15
information.
Verify the access point is operating before replacing the ceiling tile (see the
Step 16
Point" section on page

Installing Option Two

Option two consists of two B-Line mounting systems mounted on each end of the mounting bracket. The
steps are basically the same as those in the
box hangers are positioned as shown in Figures
Figure 2-9
OL-8247-03
2-26).
1-3).
The access point 5-GHz antenna connectors have a blue label to correspond with the blue dot or
label on the Cisco Aironet 5-GHz antennas or antenna cables.
2-22).
Left Side Box Hanger Mounting Details (B-Line)
"Mounting Plate Attached to a Surface" section
"Securing the Access Point" section on page 2-27
"Installing Option One" section on page 2-13
2-9 and 2-10.
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
Mounting Above a Suspended Ceiling
Figure 2-24).
for additional
"Powering Up the Access
except that the
2-15