Checking The Lightweight Access Point Leds - Cisco AIR-AP1252AG-A-K9 Hardware Installation Manual

Chapter 4 Troubleshooting 1250 Series Lightweight Access Points

Checking the Lightweight Access Point LEDs

Checking the Lightweight Access Point LEDs
If your lightweight access point is not working properly, check the Status, Ethernet, and Radio LEDs on
the 2.4 GHz end of the unit. You can use the LED indications to quickly assess the unit's status.
Figure 4-1 shows the access point LEDs (for additional information refer to the Event Log using the
access point browser interface).
Figure 4-1 Access Point LEDs
ETHERNET STATUS RADIO
ETHERNET STATUS RADIO
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
4-3
OL-8247-03