Manually Configuring Controller Information Using The Access Point Cli - Cisco AIR-AP1252AG-A-K9 Hardware Installation Manual

Manually Configuring Controller Information Using the Access Point CLI

3. Cisco switches that support Intelligent Power Management always configure the use of a power injector at the switch.
4. The access point detects the power injector (AIR-PWRINJ4).
Table 4-4 Using CLI Power Commands for Access Points with Two Radio Module Installed
Power Source
AC power module
Cisco switch that supports Intelligent Power
1
Management
Cisco switch that does not support Intelligent Power
1
Management
2
Power injector used with a Cisco switch that
supports Intelligent Power Management
2
Power injector used with a Cisco switch that does not
support Intelligent Power Management
2
Power injector used with a non-Cisco switch
802.3af compliant non-Cisco switches
1. You should check the release notes for your Cisco power source to determine which Cisco IOS release supports Intelligent Power Management. Support
for Intelligent Power Management might not be currently available for your Cisco power source.
2. Power injector must be AIR-PWRINJ4.
3. Cisco switches that support Intelligent Power Management always configure the use of a power injector at the switch.
4. The access point detects the power injector (AIR-PWRINJ4).
Manually Configuring Controller Information Using the Access
Point CLI
In a new installation, when your access point is unable to reach a DHCP server, you can manually
configure needed controller information using the access point CLI. For information on how to connect
to the console port, see the
The CLI commands in this section can be used only on an access point that is not associated to a
Note
controller.
The static information configured with the CLI commands are used by the access point to connect with
a controller. After connecting with the controller, the controller reconfigures the access point with new
controller settings, but the static IP addresses for the access point and the default gateway are not
changed.
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
4-12
Cisco Wireless LAN Controller
None required
None required
config ap power pre-standard enable
None required
1
None required
1
None required
A 1250 power injector is required
"Connecting to the Access Point Locally" section on page
Chapter 4 Troubleshooting 1250 Series Lightweight Access Points
CLI Commands
4
Cisco Switch
power inline never
power inline never
power inline never
3
power inline never
power inline never
–
–
4-14.
OL-8247-03