Manually Configuring Controller Information Using The Access Point Cli - Cisco Aironet 1240AG Series Hardware Installation Manual

Chapter 4 Troubleshooting 1240AG Series Lightweight Access Points
You can use these controller CLI commands to inform the access point of the following:
•
•
Refer to
corresponding Cisco switch power command.
If the access point receives power through PoE, the output current of the power sourcing equipment
Caution
(PSE) cannot exceed 400 mA per port. The power source must comply with IEEE 802.3af or IEC60950
for limited power sources.
Table 4-2 Using CLI Power Commands
Power Source
AC power module
Cisco switch that supports Intelligent Power
1
Management
Cisco switch that does not support Intelligent
1
Power Management
2
Power injector used with a Cisco switch that
supports Intelligent Power Management
2
Power injector used with a Cisco switch that
does not support Intelligent Power
1
Management
Power injector used with a non-Cisco switch
802.3af compliant non-Cisco switches
1. You should check the release notes for your Cisco power source to determine which Cisco IOS release supports Intelligent Power Management. Support
for Intelligent Power Management might not be currently available for your Cisco power source.
2. Power injector must be AIR-PWRINJ3 or AIR-PWRINJ-FIB.
3. Cisco switches that support Intelligent Power Management always configure the use of a power injector at the switch.
Manually Configuring Controller Information Using the Access
Point CLI
In a new installation, when your access point is unable to reach a DHCP server, you can manually
configure needed controller information using the access point CLI. For information on how to connect
to the console port, see the
The CLI commands in this section can be used only on an access point that is not associated to a
Note
controller.
OL-8371-05
The Cisco switch does not support Intelligent Power Management but should be able to supply
sufficient power.
A power injector is being used to supply sufficient power and the Cisco switch does not support
Intelligent Power Management.
Table 4-2 for information on when to use these special CLI controller commands and the
Cisco Wireless LAN Controller
None required
None required
config ap power pre-standard enable
None required
1
config ap power injector enable
None required
None required
"Connecting to the Access Point Locally" section on page

Manually Configuring Controller Information Using the Access Point CLI

CLI Commands
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
Cisco Switch
power inline never
power inline auto
power inline auto
3
power inline never
power inline never
–
–
4-11.
4-7