Assembling The Stand; Assembling The Stand Components; Assembling The Table Plate And Attaching It To The Stand - DURKOPP ADLER 367 Installation Instructions Manual

3.

Assembling the stand

3.1

Assembling the stand components

3.2

Assembling the table plate and attaching it to the stand

–
Assemble the individual stand components as shown in the
illustration.
–
Insert the upper-part support 1 in the hole in the table plate.
–
Insert the hinge bases 3 for the machine head into the recess in the
table plate 4 and screw in place.
–
Insert the rubber corner 8.
–
Screw the drawer 5 with its mountings under the table plate on the
left-hand side.
–
Screw the main switch 12 under the table plate on the right-hand
side.
–
Screw the cable conduit 10 under the table plate behind the main
switch 12.
–
Screw the holder 9 for the mains-lead cleat under the table plate
behind the cable conduit 10.
–
Screw the sewing-lamp transformer 11 (optional equipment) under
the table plate.
–
Attach the table plate 4 to the stand with woodscrews (B8 x 35)
(see sketch for position).
–
Insert the reel stand 7 in the hole in the table plate and secure it
with the nuts and washers.
Fit and align the yarn-reel and unwinding holders.
The yarn-reel holder and the unwinding arm must be vertically in
line.
–
Screw the holder for the oil-can 6 onto the left-hand stand brace.
7