Connecting The Receiver To A Dish Antenna System - Dish Network 512 User Manual

Connecting the Receiver to a Dish Antenna System

: Before you can begin connecting your receiver to your dish antenna, you
Note
must first complete the preceding sections on connecting your TVs to the
receiver. If your dish antenna system has been installed and peaked for
maximum signal strength, then complete the following instructions to connect
the dish antenna system to the receiver.
: You will need two available receiver connection ports on your installed
Note
switch or LNBF to complete this installation. If these ports are not available,
you may need to upgrade your system with different or additional equipment.
1. Connect two RG-6 coaxial cables between the
S I 2
ATELLITE N
either your switch or your LNBF in your existing system. See the wiring
diagrams in Chapter 4 for appropriate receiver connections in your system.
: If you are installing your receiver into a system with DISH Pro
Note
LNBFs (and/or switches), you can have as much as 200 feet of cable
between the LNBF and the receiver. However, you must use only RG-6
coaxial cables rated for 950 to 2150 MHz. These cables may say "Swept
tested for 2150 MHz." If you have any doubt about this, ask your DISH
retailer, or look on the container the cable came in. Do not use cable-TV
company cables or cables from other satellite TV systems not rated for 950-
2150 MHz. These other cables may cause signal loss. Do not use existing
cables such as RG-59. Always use waterproof F-connectors outdoors.
2. Peel off the blue stickers and affix them to the cables close to where they
connect to the
S
the receiver.
3. On the IR remote control, press MENU-6-1-1 to display the
screen on the nearby TV.
Signal
4. Select
Check Switch
5. The receiver begins performing the
Connecting the Receiver to a Dish Antenna System
Satellite Connections
1
2
ports on the receiver's back panel to two available ports on
and
I 1 S
ATELLITE N ATELLITE
. When an attention screen displays, select
Check Switch
and
S I 1
ATELLITE N
connections on the back of
I 2
N
Point Dish/
Retest
tests. When the receiver
Tip: Using cable
labels makes it
easy to tell which
cables connect to
the receiver ports.
Inside the front
cover of this guide
are stickers that
are color coded
the same way as
the coaxial
connections.
.
Page 29