Dish Network 512 User Manual page 62

–
Stop Recording Manually
press STOP. Note that failing to press STOP could continue
recording and fill the DVR hard drive!
–
Extend End Time
–
Create a Recurring Timer
described in Setting Up an Automatic Event Timer on page 57.
–
Record the Entire Event
scheduled end of the current program or event.
Setting Up an Automatic Event Timer
1. Find a future program by using the
, the
Banner Themes
The program can be on a satellite-delivered or over-
the-air (OTA) channel, if applicable. With the
program highlighted, press the SELECT button.
2. Select a
Timer Frequency
page 55. Notice that a mark displays in the box next to your selection.
3. Select a
Timer Type
selection is indicated on the screen.
4. Select any applicable timer
5. Select the
Create Timer
6. The
Program Guide
your satellite receiver is scheduled to record the event.
Setting Up a Manual Event Timer
1. Press the MENU button and select
2. Select the
Timers
3. Select the
Manual Timers
- The receiver will record until you
- You can set the stop time for the recording.
- You can set up a timer like the one
- The receiver stops the recording at the
Browse
menu, or the
Program Guide
option. See "Event Timer Frequency" on
. See "Event Timer Types" on page 55. Again, your
; to change priority, select
Options
option to save the new event timer.
displays a small indicator of which of the two tuners in
Daily Schedule
option.
option. The receiver displays a timer menu.
.
Set Priority.
.
Using Timers
Tip: You can edit
and delete timers
from any TV that is
connected to one
of the TV1 outputs.
Tip: The IR remote
control is used to
control the menus
and programming
on the nearby TV.
An optional IR/UHF
Pro remote is
available
separately, and can
control the receiver
from another room.
Page 57