Dish Network 512 User Manual page 30

3. Plug in the power cord for the receiver.
4. Turn on the receiver with the front-panel power button and make sure the
green TV1 power indicator is lit.
5. Turn on the nearby TV.
6. Tune the TV to channel 3.
7. You should see the
8. If you do not see the
: If you want to change the channel that the
Note
your TV, see Changing the TV1 Output Channel on page 27.
9. If desired to remind you of which TV channel (3 or 4) to tune to watch
satellite programming, place one of the channel stickers (3 or 4) near or on
your TV. The stickers are located in the inside front cover of this guide.
RCA and S-Video Connections (TV1)
1. Connect one of the following video cables:
-type video cable (yellow) from the receiver
• RCA
your TV's
RCA
• cable from the receiver
S-V
IDEO
2. Connect the stereo
output ports to your TV's audio inputs. If the TV has only one (mono) input
for this type of audio, connect it to the right (R) phono-plug (RCA-type)
audio output on the satellite receiver.
3. Make sure your TV is on and set to receive TV from the correct audio and
video inputs. Refer to the instructions that came with your TV.
4. Plug in the power cord for the receiver.
5. Turn on the receiver with the front-panel power button and make sure the
green TV1 power indicator is lit.
6. You should see the
Confirm Remote Control Operation
After your TV has been connected to a
described above, you can do the following to confirm that the supplied DISH
Network IR remote controls the satellite receiver:
1. Make sure that fresh batteries are installed properly in the IR remote
control.
2. Press the SAT button to put the IR remote control in SAT mode to control
the satellite receiver.
3. Use the remote control arrow buttons to move around the
screen. If you are able to move around in the
have confirmed that the remote is controlling the receiver.
Connecting the Receiver to Your Nearby TV
screen.
Point Dish
screen, tune the TV to channel 4.
Point Dish
video input connector.
output to your TV's
TV1
audio cables (red and white) from the receiver
RCA
screen.
Point Dish
output using one of the methods
TV1
port provides to
CH 3-4
output ports to
TV1
S-V
IDEO
Point Dish
screen, then you
Point Dish
input.
TV1
Page 25