Using The Remote Control - Dish Network 512 User Manual

Chapter 3
Using the System
Tip: The included
remote uses IR to
control the menus
and programming
on a nearby TV. Be
sure to point this
remote control
directly at the front
of your receiver.
Page 38
3. Press the SWAP button. The channel that was shown in the PIP window
will now be shown on the full screen.
4. Press the PIP button again to enlarge the
5. Press the PIP button once more to close the

Using the Remote Control

The following section describes how to use the remote control with your
satellite receiver. The remote control must be in SAT mode for the buttons to
control the satellite receiver. You can also use the remote to control your DVD
player, VCR, or other devices. See Control Other Devices with the Remote on
page 85.
SAT Mode Button
Press the SAT mode button to set the remote to SAT mode, to control the
receiver. The SAT mode button's back light turns ON briefly to show that the
remote is set to SAT mode.
window.
PIP
window.
PIP