Programming Your Remote Control - DirecTV HD RECEIVER User Manual

Programming Your Remote Control

You can program the DIRECTV Remote Control to operate your TV power, volume and mute, additional equipment such as a DVD, VCR,
stereo, or a second TV or DIRECTV
1.
Press MENU to display the on-screen Menu.
2.
Highlight "Parental, Fav's & Setup" and press SELECT.
3.
Highlight "System Setup" and press SELECT.
4.
Press SELECT on "Remote" in the left menu.
5.
Follow the on-screen instructions to program your remote for your TV or additional equipment (AV1 and AV2).
Once your remote is programmed to work with your TV, the VOL and MUTE key control the TV regardless of the MODE slide switch
position. If you would like to change the VOL and MUTE to work with other audio equipment, such as a stereo, you can. When you
program the remote for the audio equipment, on-screen instructions will direct you on how to do this.
Factory Defaults
To reset the remote control and clear all but DIRECTV Mode, follow these steps:
1.
Point the remote away from your DIRECTV
above the slide switch on the remote flashes twice (about 5 seconds).
2.
Enter 9-8-1. The light on the remote will flash four times, indicating you have cleared AV1, AV2 and TV modes.
Receiver.
®
Receiver and components. Press and hold MUTE and SELECT until the light
®
Programming Your Remote Control
Connections for TV and Auxiliary Equipment
Chapter 3 -
65