Valet Take-Over; Directed Electronics, Inc - Directed Electronics Rattler 259D User Manual

1. Start the engine by pressing
2. Press and release
3. Within two seconds press and release
4. The engine will shut down and the parking lights will flash
four times to confirm that Timer Mode has been exited. If
the car has already been remote started, skip Step One.

valet take-over

The Valet® Take-Over feature allows the vehicle to remain
running after the key has been removed from the ignition. This
feature is useful for occasions when you wish to exit and lock the
vehicle for short periods of time, but would like to leave the
motor running and the climate controls on.
To perform Valet Take-Over:
1. Before turning off the engine, press and release
on the transmitter.
2. Turn the ignition key to the OFF position. The engine will
stay running.
3. The engine will run until the pre-programmed time elapses
or a shut-down input is received. (See the previous Remote
Start section for a complete list of shut-down inputs.)
note: This feature will not work if the brake pedal is
being pressed.
34
and .
.
and
© 2002 directed electronics, inc.
again.
and