Timer Mode - Directed Electronics Rattler 259D User Manual

timer mode

Timer Mode automatically starts the engine and runs it for a
pre-programmed time period, every three hours for a total of six
operation cycles. This feature helps to ensure that your engine
will start in the morning after a night of extremely cold temper-
atures.
important! This feature must only be used in open areas,
never in an enclosed area such as a garage.
To enter Timer Mode:
1. Start the vehicle by pressing and releasing
2. Press and release
3. Within two seconds press and release
The engine will shut down and the parking lights will flash four
times. The engine will then restart to confirm that Timer Mode
has been entered.
The engine may be allowed to run for its preset time or can be
shut down by pressing Buttons
will restart every three hours for a total of six cycles. If the unit
receives a shutdown input while operating in the timer mode the
engine will stop, but will restart, on schedule, again in three hours.
To exit Timer Mode:
Timer Mode can be exited by turning the ignition on with the
key any time the engine is not running. You can also exit Timer
Mode manually from the transmitter by following these steps:
© 2002 directed electronics, inc.
and
.
and
and again. Either way, it
.
again.
33