Chapter 2
Installing the Cisco IP Conference Station 7936
Configuring Startup Network Settings
Guidelines for Best Performance
Note
OL-4746-01
If you are not using DHCP in your network, you must manually configure the
following network settings on the IP Conference Station after installing the
station on the network:
IP address
•
IP subnet mask
•
Default gateway IP address
•
TFTP server IP address
•
Collect the necessary information and follow the procedures described in
Chapter 3, "Configuring the Cisco IP Conference Station
Follow these guidelines to ensure optimum performance with the
IP Conference Station 7936 and the external microphones.
See the
"Conference Room Setup Examples" section on page 2-22
illustration of proper equipment placement for different conference room
configurations.
Use the IP Conference Station in closed offices and conference rooms up to
•
20 feet by 20 feet (without external microphones) and 20 feet by 30 feet (with
external microphones).
Place the IP Conference Station 7936 base on a flat surface and make sure
•
that it is clear from any reflective surfaces.
Maintain a minimum distance of four feet between each external microphone
•
and the IP Conference Station 7936 base and other objects.
Make sure that all microphones are acoustically unobstructed.
•
Position the external microphones toward the areas that need to be covered,
•
and so that the main pickup direction is pointed away from the
IP Conference Station 7936.
Installing the Cisco IP Conference Station 7936
Cisco IP Conference Station 7936 Administration Guide
7936".
for an
2-21