Using Auto-Registration - Cisco IP CONFERENCE STATION 7936 Administration Manual

Preparing to Install

Using Auto-Registration

Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Note
Cisco IP Conference Station 7936 Administration Guide
2-4
Use auto-registration to automatically add an IP Conference Station to the
network and assign a directory number to it. The directory number assigned is the
next available sequential number within the device pool assigned to the
conference station type in Cisco CallManager.
When you enable auto-registration in Cisco CallManager, the
IP Conference Station begins the automatic startup process to obtain a directory
number after the station is connected to the network.
You can also use auto-registration to quickly register all stations with the
Cisco CallManager database. You can then modify any settings, such as the
directory numbers, from the Cisco CallManager application.
The following procedure provides an overview of the steps you must perform in
Cisco CallManager:
Start Cisco CallManager Administration.
Enable auto-registration in Cisco CallManager by selecting
System > Cisco CallManager.
From the list of Cisco CallManagers, select the Cisco CallManager where you
want to check auto-registration.
Verify that the "Auto-registration Disabled on this Cisco CallManager" setting is
not selected.
Install the station by following the instructions in the
Cisco IP Conference Station 7936" section on page
To modify settings, return to Cisco CallManager Administration and select
Device > Phone.
Enter search criteria for the new IP Conference Station and click Find. You
should see the MAC address for the new IP Conference Station.
Refer to the Cisco CallManager Administration documentation or online help in
the Cisco CallManager Administration application for additional information.
Chapter 2 Installing the Cisco IP Conference Station 7936
"Installing the
2-6.
OL-4746-01