Changing Dhcp Settings; Enabling Dhcp - Cisco IP CONFERENCE STATION 7936 Administration Manual

Accessing Network Configuration Settings
Step 4
Step 5
Step 6
Timesaver

Changing DHCP Settings

Enabling DHCP

Step 1
Step 2
Step 3
Cisco IP Conference Station 7936 Administration Guide
3-8
Enter the administrator password. (The default administrator password is **#.)
Press the Enter softkey.
Press the Up or Down scroll button to select Network Setup, and then press the
Select button.
You can now access and change certain network parameters, including DHCP,
static IP addressing, IP mask, DNS, Administrative VLAN, and Alternate TFTP.
You can also use the Cisco IP Conference Station 7936 web interface to change
network options. See the
section on page 3-33.
DHCP automatically assigns IP addresses to devices when you connect them to
the network. Follow the appropriate procedures in this section to enable or disable
DHCP.
DHCP is enabled by default.
Follow these steps to reset DHCP if it becomes disabled:
From the Network Setup menu, press the Up or Down scroll button to select
DHCP.
If DHCP is disabled, the option displays as:
DHCP Disabled
Press the Enable softkey to enable DHCP.
Press the Save softkey.
Chapter 3 Configuring the Cisco IP Conference Station 7936
"Cisco IP Conference Station 7936 Web Interface"
OL-4746-01