Using The Keyboard Commands - Cisco IP CONFERENCE STATION 7936 Administration Manual

Chapter 2 Installing the Cisco IP Conference Station 7936

Using the Keyboard Commands

Keyboard Command
**#
**#**
**1
**5
**6
**4
**7
<Select, Select>
OL-4746-01
The following keyboard commands are available for use on the
Cisco IP Conference Station 7936.
Accessible State
In menu screens.
In resting mode and two
levels of menu screens.
For example, you could use
this keyboard command
from the Main menu
(first level) or from the
Admin Setup menu
(second level).
In resting mode.
In resting mode.
In resting mode.
In resting mode.
In resting mode.
During an active call.
Using the Cisco IP Conference Station 7936
Feature Description
Use this command to access the Administrator
menus.
Use this command to restart the
IP Conference Station.
This command restores the default
configuration of the IP Conference Station. A
confirmation screen is displayed before
execution.
This command displays a list of LCD tests.
This command displays the MAC address of the
IP Conference Station.
Use this command to enable a Telnet connection
to the phone. Telnet will be enabled until the
phone is reset.
Use this command to invoke the digital signal
processor (DSP) state information display.
To see the DSP information, this must be
Note
done prior to a call being made.
Once you are in a call, press the Select key to
display; the DSP information will be displayed
for the remainder of the call.
This command displays the active call statistics
and the codec that is in use.
Cisco IP Conference Station 7936 Administration Guide
2-29