Visioneer STROBE XP 300 User Manual page 21

14 V S
ISIONEER TROBE
XP 300 S U '
CANNER SER S
Note: If the page does not back out of the scanner, the calibration
may not have finished properly. Remove the page and complete the
installation of your scanner, then see the section, "Recalibrating or
Cleaning Your Scanner" on page 115 to run the calibration again.
4. Remove the sheet and replace it in its plastic bag.
Do not discard the calibration sheet. You may need it periodically
to calibrate the scanner to keep it operating at peak performance.
Do not proceed until you receive a message that your computer has
found the new hardware, or updated the driver database. If your
computer is running Windows XP or Windows Vista, you will see a
message similar to the following.
G
UIDE