Other Settings; Misc. Settings - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

Table 4-11 SNMP Settings (continued)
Item

Other Settings

This item provides access to a variety of management and printing configuration options. The
following tabs are provided:
■
Misc. Settings: for enabling miscellaneous advanced protocols and functions
■ Firmware
■ LPD Queues: for setting up print queues used in printing under LPD (line printer daemon)
printing services
■ Support
■ Refresh

Misc. Settings

The Miscellaneous Settings parameters allow you to set a variety of advanced protocols and
features, as described below. See
Table 4-12 Miscellaneous Settings
Item
SLP Config
Telnet Config
mDNS
Multicast IPv4
78 Chapter 4 HP Jetdirect Embedded Web Server (V.31.xx)
Description
When enabled, an SNMP v3 account must be created on the print server, and the account
information must be implemented on the SNMP v3 management application. You may
create an account by providing the following information:
User Name: the SNMP v3 account user name.
Authentication Key: a 16-byte hexadecimal value for authenticating the SNMP packet
contents using the Message Digest Algorithm 5 (MD5, RFC 1321).
Privacy Key: a 16-byte hexadecimal value for encrypting the data portion of the SNMP
packet using the Data Encryption Standard (DES) algorithm.
Context Name: the view context in which this user can access SNMP objects. It is always
"Jetdirect".
Upgrade: to update your HP Jetdirect print server with new features and enhancements
Info: to set up the Support link located under Other Links in the left margin
Rate: to set the time interval (in seconds) for embedded Web diagnostic page updates
Table 4-12 Miscellaneous
Description
Enable or disable SLP (Service Location Protocol), used by selected client application
software to automatically discover and identify the HP Jetdirect print server.
If SLP will use multicast protocols, Multicast IPv4 must be enabled.
Enable or disable access to HP Jetdirect configuration parameters using Telnet. For
more information, see
Enable or disable Multicast Domain Name System (mDNS) services. mDNS is typically
used on small networks for IP address and name resolution (through UDP port 5353)
where a conventional DNS server is not used.
For mDNS operation, Multicast IPv4 must be enabled.
Enable or disable the receipt and transmission of IP version 4 multicast packets by the
print server. If this parameter is disabled, other protocols that use multicast protocols,
such as mDNS and SLP, may also be disabled without notification.
Settings.
TCP/IP Configuration.
ENWW