User Interface Options - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

To set configuration parameters, you must set up a Telnet session from your system to the HP
Jetdirect print server.
1 Type the following at the system prompt:
telnet <IP address>
where <IP address> is the IP address listed on the Jetdirect configuration page. See
Jetdirect Configuration
2 A connection to the HP Jetdirect print server will be displayed. If the server responds with
"connected to IP address", press
initialized.
3 If prompted for a user name and password, enter the correct values.
By default, the Telnet interface does not require a user name or password. If an administrator
password has been set, you will be prompted for a user name and this password before you can
enter and save Telnet command settings.
4 By default, a Command Line interface is provided. To configure parameters using a Menu
interface, enter Menu. For more information, see
For a list of supported commands and parameters, see

User Interface Options

The HP Jetdirect print server provides two interface options to enter Telnet commands: a
Line Interface (Default)
44 Chapter 3 TCP/IP Configuration
Pages.
Enter twice to make sure that the Telnet connection is
and a Menu Interface.
"User Interface Options".
Table 3-3 Telnet Commands and
HP
Parameters.
Command
ENWW