Using Dhcp (Ipv4) - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

Table 3-2 TFTP Configuration File Parameters (continued)
CAUTION
version than the currently installed version. The print server will attempt to upgrade when the upgrade file
contains a higher version than the installed version.
The command format is:
upgrade: <TFTP server IP> <Version> <Product Number> <Filename>
where,
<TFTP Server IP> is the IP address of the TFTP server,
<Version> specifies the firmware version of the upgrade file,
<Product Number> specifies and must match the product number of the print server,
<Filename> is the path and filename of the firmware upgrade file.
status-page-lang:
■ Specifies the page description language (PDL) that the print server will use to send the Jetdirect configuration/status
page to the printer.
■ Auto (default): The PDL is auto-detected when the print server is powered on or after a cold-reset.
■ PCL: Hewlett-Packard Printer Control Language
■ ASCII: Standard ascii characters
■ HPGL2: Hewlett-Packard Graphics Language (v2)
■ PS: Postscript language
Support
support-name:
■ Typically used to identify the name of a person to contact for support of this device.
support-number:
■ Typically used to specify a phone number or extension to call for support of this device.
support-url:
■ A Web URL for product information on this device over the Internet or an intranet.
tech-support-url:
■ A Web URL for technical support over the Internet or an intranet.

Using DHCP (IPv4)

Dynamic Host Configuration Protocol (DHCP, RFC 2131/2132) is one of several auto configuration
mechanisms that the HP Jetdirect print server uses. If you have a DHCP server on your network, the
HP Jetdirect print server automatically obtains its IP address from that server and registers its name
with any RFC 1001 and 1002-compliant dynamic name services as long as a WINS (Windows
Internet Naming Service) server IP address has been specified.
36 Chapter 3 TCP/IP Configuration
Ensure that command parameters are properly entered and that the upgrade file is a higher
(or support-contact:)
ENWW