Lubrication - Epson 2200 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus PHOTO 2100/2200
6.1.3.2 Maintenance
Request
Ink is used for operations such as head cleaning as well as printing. In that case, the ink
is drained into the Waste ink pad and its amount is counted by the Protection counter A
(Waste ink counter) set in the EEPROM on the control board. When the preset value is
reached, the Waste ink counter detects that the Waste ink pad has reached its
predetermined limit, and the printer displays "Maintenance request" to indicate that the
Waste ink pad should be replaced.
!
Protection Counter A Limit:
Up to 60352
!
Timing for Replacing the Waste Ink Pad:
"
When the Protection counter A reaches the above level, the printer displays
"Maintenance request" and does not accept switch inputs except the power
switch.
"
You can check the value of the Protection counter A in Chapter 5
"ADJUSTMENT".
During repair servicing, therefore, check the counter independently of the
repair items. If the Protection counter A value of the printer is close to its
limit, notify your customer and recommend that the Waste ink pad be
replaced (if the Waste ink pad is not replaced at that time, the printer is
expected to be returned for repair in the near future due to a "Maintenance
request" error). Once you have the confirmation of the customer, replace the
Waste ink pad and reset the counter.
"
Under the specific conditions, the limit level of the counter is preset to 25000
pages for black ink or to 10000 pages for color ink. We assume that the limit
level will be reached in about 5 years in normal use.
!
Replacement Procedure:
Replacement of Waste Ink Pad in Disassembly and Assembly
(Refer to 4.2.3 "Removing the Waste Ink Pads" on page 131.)
!
After the Replacement:
• Reset the Protection Counter A (Refer to Chapter 5 "ADJUSTMENT" )
• Panel Operation (Refer to 1.3.6 "Special Setting Mode Function" on page 29.)
MAINTENANCE

6.1.4 Lubrication

The lubrication used for the components of the printer has been decided on based on
evaluation carried out by Epson. As a result, the specified amount of lubricant should
be applied in the places specified when carrying out repair and maintenance work.
"
Never use oil or grease other than those specified in this manual.
Use of different types of oil or grease may damage the
components or affect the printer functions.
"
Never apply a larger amount of oil or grease than specified in
this manual.
Table 6-1. Oil Applied to the Stylus PHOTO 2100/2200
Type
Grease
Grease
Grease
Oil
Table 6-2. Lubrication Points
Ref.
Lubrication Type/Point
No.
!
<Lubrication Point>
Inside the bush 12 (right) mounted on the frame
(middle).
!
<Lubrication Type>
1
G-26
!
<Lubrication Amount>
φ1mm x 3mm
!
<Lubrication Point>
Driven Pully Holder
!
<Lubrication Type>
2
G-26
!
<Lubrication Amount>
φ1mm x 2mm x 8 points
Overview
Name EPSON CODE
G-26 B702600001
G-45 T.B.D
G-56 1059150
O-12 1038991
Use a brush to apply it.
Refer to Figure 6-3.
Refer to Figure 6-4.
Revision B
Supplier
EPSON
EPSON
EPSON
EPSON
Remarks
217