Removing The Housings - Epson 2200 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus PHOTO 2100/2200

4.2.1 Removing the Housings

4.2.1.1 Removing the Upper Housing
1. Open the Printer Cover and Stacker.
2. Remove the two clips, which are fitted in the front of the Upper Housing as viewed
from the printer front, by inserting a flat-blade screwdriver into the clip gaps.
3. Remove the four screws 1) C.B.S 3
Housing.
Clips
Figure 4-3. Screws That Secure the Upper Housing
DISASSEMBLY AND ASSEMBLY
×
14 (9±1kgf.cm) that secure the Upper
Upper Housing
C.B.S 3×14
4. Release a total of six cutouts, which secure the Upper Housing, from the hooks of
the Middle Housing.
The left and right cutouts of the Upper Housing can be released easily by pushing
them from inside the printer. To release the right-hand side cutouts, however, the
CR Lock Lever must be moved to the front position, as viewed from the printer
front, using tweezers or like and the CR Unit moved to near the printer center.
Fully be careful when handling the two cutouts on the left/right of
the Upper Housing, as viewed from the printer front, since they
are easily broken.
Refer to Figure 4-4, "Hooks That Secure the Left and Right of the
Upper Housing".
Cutouts
CR Unit
CR Lock Lever
Figure 4-4. Hooks That Secure the Left and Right of the Upper Housing
Disassembly
Revision B
Cutouts
121