Epson 2200 - Stylus Photo Color Inkjet Printer Service Manual page 177

EPSON Stylus PHOTO 2100/2200
"
Since the joggle of the Bush 12 is easily damaged, fully be careful
when removing and reinstalling it.
Refer to Figure 4-128, "Removing the PF Roller".
"
When sliding the PF Roller, fully take care so that the coating of
the PF Roller is not peeled off by the Lower Driven Roller and by
the hook on the left side of the PF Roller Support Lever as seen
from the printer front.
Refer to Figure 4-127, "Removing the Extension Spring 9.65".
9. After sliding the PF Roller to the top front as viewed from the printer front, lift and
remove it from the Left Frame.
"
When removing the PF Roller, fully be careful not to scratch the
PF Loop Scale.
Refer to Figure 4-128, "Removing the PF Roller".
"
When handling the PF Roller, wear gloves since the paper
loading accuracy will decline if you touch its surface directly
with bare hands.
Refer to Figure 4-128, "Removing the PF Roller".
"
When cleaning the surface, use a soft, clean brush.
Refer to Figure 4-128, "Removing the PF Roller".
In the ASP structure, the PF Roller Unit consists of the PF Roller
and Spur Gear 76 (including the Bush 12) and does not include the
PF Scale. Place an order for the PF Scale as required.
DISASSEMBLY AND ASSEMBLY
"
When changing the PF Roller, the following adjustments are
necessary. Make the adjustments in the following order.
1. PG adjustment
2. CR tooth skip prevention mechanism adjustment
3. Head cleaning
4. Head angular adjustment
5. Bi-D adjustment
6. PF adjustment
"
Refer to "Chapter 5 Adjustment" for the adjustment
procedures.
"
After changing the following parts for new ones, always apply
grease G-26 in the specified positions.
• Bush 12 (Right):
Refer to Chapter 6, Figure 6-3, "Lubrication Point 1".
• Rear Paper Guide:
Refer to Chapter 6, Figure 6-8, "Lubrication Point 10".
• PF Roller and PF Grounding Spring:
Refer to Chapter 6, Figure 6-8, "Lubrication Point 10".
• Front Paper Guide:
Refer to Chapter 6, Figure 6-12, "Lubrication Point 14".
Disassembly
Revision B
177