Epson 2200 - Stylus Photo Color Inkjet Printer Service Manual page 172

EPSON Stylus PHOTO 2100/2200
3. Release the one hook on the DE Unit (ASF Mounting Plate) that secures the DE
Lock Lever, and slide the DE Lock Lever to the left as seen from the printer rear,
to remove the right end of the DE Lock Lever from the DE Unit mounting hole,
lower it, and pull it off to the right.
Hook
Left rear side
Figure 4-115. Removing the DE Lock Lever
4. Release the one hook that secures the Spur Gear 26.4, and remove the Spur Gear
26.4 from the Under Frame.
Hook
Figure 4-116. Removing the Spur Gear 26.4
DISASSEMBLY AND ASSEMBLY
DE Lock Lever
1
DE Unit mounting
hole
3
2
Spur Gear 26.4
5. Loosen the one screw 6) C.B.S 3
remove the Extension Spring 9.27 that engages the Under Frame and DE Unit
Lever, and remove the Timing Belt from the Combination Gear 12, 22.92.
DE Unit Lever
Extension Spring 9.27
Figure 4-117. Removing the Timing Belt
6. Remove the two Harness Clamps and release the Harness of the ASF/Pump Motor
from the mini-clamps. (Refer to Steps 2 to 4 in 4.2.13.1.)
7. Disconnect the Connector Cable (CN8) of the ASF/Pump Motor from the Main
Board. (Refer to Steps 2 and 3 in 4.2.2.2.)
Disassembly
Revision B
×
6 (9±1kgf.cm) that secures the DE Unit Lever,
Timing Belt
C.B.S 3×6
Combination
Gear 12,22.92
172