Procedure: Provision An Etherswitch Point-To-Point Circuit (Multicard Or Single-Card); Figure 9-5 A Multicard Etherswitch Point-To-Point Circuit; Figure 9-6 A Single-Card Etherswitch Point-To-Point Circuit - Cisco 15454-TCC - Network Processor Card Operation Manual

Chapter 9 Ethernet Operation
Figure 9-5
192.168.1.25
255.255.255.0
VLAN test 1
Slot 4, port 1
192.168.1.100
255.255.255.0
VLAN test 1
Slot 5, port 1
Figure 9-6
192.168.1.25
255.255.255.0
VLAN test
Slot 4

Procedure: Provision an EtherSwitch Point-to-Point Circuit (Multicard or Single-Card)

Display CTC for one of the ONS 15454 Ethernet circuit endpoint nodes.
Step 1
Double-click one of the Ethernet cards that will carry the circuit.
Step 2
Click the Provisioning > Card tabs.
Step 3
Step 4 If you are building a Multicard Etherswitch point-to-point circuit:
a.
b.
c.
If you are building a Single-card Etherswitch circuit:
d.
e.
November 2001
A Multicard EtherSwitch point-to-point circuit
ONS 15454
#2
A Single-card Etherswitch point-to-point circuit
ONS 15454
#2
Under Card Mode, verify that Multi-card EtherSwitch Group is checked.
If Multi-card EtherSwitch Group is not checked, check it and click Apply.
Repeat Steps 2 – 4 for all other Ethernet cards in the ONS 15454 that will carry the circuit.
Under Card Mode, verify that Single-card EtherSwitch is checked.
If Single-card EtherSwitch is not checked, check it and click Apply.
ONS 15454
#1
ONS 15454
#3
ONS 15454
#1
ONS 15454
#3
Cisco ONS 15454 Installation and Operations Guide
Ethernet Circuit Configurations
192.168.1.50
255.255.255.0
VLAN test 1
Slot 15, port 1
192.168.1.75
255.255.255.0
VLAN test 1
Slot 17, port 1
SONET
Ethernet
192.168.1.50
255.255.255.0
VLAN test
Slot 15
9-7