Table of Contents
Advertisement
SNMP Support
Figure 11-4 Setting up SNMP
Type the IP address of your NMS in the IP Address field.
Step 4
Type the SNMP community name in the Community Name field.
Step 5
For a description of SNMP community names, see the
page
11-8.
Note
Note
Step 6
Set the Trap Version field for either SNMPv1 or SNMPv2.
Refer to your NMS documentation to determine whether to use SNMP v1 or v2.
Step 7
Set your maximum traps per second in the Max Traps per Second field.
Note
Step 8
Click OK.
SNMP settings are now configured. To view SNMP information for each node, highlight the node IP
address in the Trap Destinations area of the Trap Destinations screen
Cisco ONS 15454 Installation and Operations Guide
11-4
The community name is a form of authentication and access control. The community name
assigned to the ONS 15454 is case-sensitive and must match the community name of the
NMS.
The default UDP port for SNMP is 162.
The Max Traps per Second is the maximum number of traps per second that will be sent to
the SNMP manager. If the field is set to 0, there is no maximum and all traps are sent.
"SNMP Community Names" section on
(Figure
11-5).
Chapter 11
SNMP
November 2001
Advertisement
Table of Contents
