Password Change; Firmware Upgrade - NETGEAR GS108T - ProSafe - Gigabit Smart Switch Software Administration Manual

GS108T Smart Switch Software Administration Manual

Password Change

You can set a new password of up to 20 ASCII characters.
1. Click Password Change in the Switch Setting section. The Password Change screen displays.
You can set a new password.
2. Enter the old password.
3. Enter the new password, and enter is again to confirm it.
4. Click Set to enable the new password.

Firmware Upgrade

.
Note: You can also upgrade the firmware using the File Download screen of the switch
(see "File Download" on page 6-20).
If you click Firmware Upgrade in the main screen (see Figure 1-1 on page 1-3), after you have
selected the switch to upgrade, the following screen displays:
.
Figure 1-6
1-8 Getting Started with Switch Management
v1.0, December 2007