Stopping A Zenworks Service; Restarting A Zenworks Service; Zenworks Services; A.1.5 Zenworks Services - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SYSTEM PLANNING-DEPLOYMENT-BEST PRACTICES GUIDE 10.3 30-03-2010 System Planning Manual

To start all services:
1 Enter the following command at the server console prompt:
/opt/novell/zenworks/bin/novell-zenworks-configure -c Start
A.1.3 Stopping a ZENworks Service
To stop a ZENworks service on a Windows Primary Server:
1 Click Start > Administrative Tools > Services.
2 Select the service you want to stop, then click Stop.
To stop a ZENworks service on a Linux ZENworks Primary Server:
1 Enter the following command at the server console prompt:
/etc/init.d/servicename stop
Replace servicename with the name of the service as listed in
Services," on page
A.1.4 Restarting a ZENworks Service
To restart a service that is already running on a Windows Primary Server:
1 Click Start > Administrative Tools > Services.
2 Select the service you want to start, then click Restart.
To restart a service that is already running on a Linux Primary Server:
1 Enter the following command at the server console prompt:
/etc/init.d/servicename restart
Replace servicename with the name of the service as listed in
Services," on page

A.1.5 ZENworks Services

ZENworks Services, Service Names, and Descriptions
Table A-1
Service
Proxy DHCP Service
TFTP Service
ZENworks Agent Service
ZENworks Datastore
94 System Planning, Deployment, and Best Practices Guide
94.
94.
Service Name
novell-proxydhcp
novell-tftp
zenworkswindowsservice
novell-zmd
dbsrv10
Section A.1.5, "ZENworks
Section A.1.5, "ZENworks
Description
Used with a standard DHCP server to inform
PXE-enabled devices of the IP address of the
Novell TFTP server.
Used by PXE-enabled devices to request files
that are needed to perform imaging tasks.
Used to enable the server as a managed
device.
Embedded database used for storing
ZENworks objects and resources.