Zenworks Systems Update - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SYSTEM PLANNING-DEPLOYMENT-BEST PRACTICES GUIDE 10.3 30-03-2010 System Planning Manual

Summary of Configuration Settings
server source-ip: The IP address given to the L4 device.
server real r-ps-1: The IP address of server1. This server will be selected in
server real r-ps-2: The IP address of server2. This server will be selected in
server virtual ps-v1: The virtual IP address used to configure the L4 device in ZENworks Control
Center. See
Configuring the Closest Server Default Rule
In addition to setting up and configuring the L4 switch, you need to also configure the Closest
Server Default Rule. For more information, see
10 Configuration Management System Administration
Configuring an L4 Switch Definition from Selected Servers
1 In one of the role section listings, select the check boxes for one or more servers.
2 Click L4 Switch > Create L4 Switch Definition from Selection.
3 Specify an L4 switch definition name, then click OK.
The L4 switch definition name must be either the DNS name or IP address of the L4 virtual
server.
4 Click Apply to make the change effective.
Additional Details
The created L4 switch definition is displayed in each of the listings, no matter where it is
created, with the selected servers listed under each instance of the L4 switch definition.
Servers can be members of multiple groups and L4 switch definitions.
Servers that are members of an L4 switch definition or group are no longer listed at the top
level of the server listing.

4.2.14 ZENworks Systems Update

The System Updates feature allows you to obtain updates to the Novell ZENworks 10 Configuration
Management software on a timely basis, and also allows you to schedule automatic downloads of
the updates.
Software updates are provided periodically and you can choose whether to deploy each update after
viewing its content.
For more information, see
Configuration Management System Administration
78 System Planning, Deployment, and Best Practices Guide
Step 3 on page 78.
"Introduction to ZENworks System
"Setting Up Closest Server
Reference.
Updates" in the
Reference.
Step 1 on page 78.
Step 1 on page 78.
Rules" in the ZENworks
ZENworks 10