Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SYSTEM PLANNING-DEPLOYMENT-BEST PRACTICES GUIDE 10.3 30-03-2010 System Planning Manual page 77

"Configuring an L4 Switch Definition from Selected Servers" on page 78
"Additional Details" on page 78
Foundry Networks ServerIronXL Configuration
The following example shows the configuration requirements for a Foundry Networks
ServerIronXL switch that was used for testing purposes in the Novell SuperLab. Other vendor
products are similar when it comes to configuration and the parameters used. Refer to vendor
documentation for further details.
ServerIron#sh run
Current configuration:
!
ver 07.3.03T12
no global-stp
global-protocol-vlan
!
server predictor round-robin
server sticky-age 2
server source-nat
server source-ip 151.155.184.107 255.255.252.0 151.155.187.254
!
server real r-ps-1 151.155.184.109
source-nat
port http
port http keepalive
port http url "HEAD /"
port http status_code 100 499
port ssl
port ssl keepalive
!
server real r-ps-2 151.155.184.110
source-nat
port ssl
port ssl keepalive
port http
port http keepalive
port http url "HEAD /"
port http status_code 100 499
!
server virtual ps-v1 151.155.184.108
port ssl sticky
port http sticky
track-group http 443
bind ssl r-ps-1 ssl r-ps-2 ssl
bind http r-ps-1 http r-ps-2 http
!
vlan 1 name DEFAULT-VLAN by port
no spanning-tree
!
boot sys fl sec
ip address 151.155.184.107 255.255.252.0
ip default-gateway 151.155.187.254
snmp-server community ..... rw
!
end
Performing Design Activities 77