Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SYSTEM PLANNING-DEPLOYMENT-BEST PRACTICES GUIDE 10.3 30-03-2010 System Planning Manual page 97

If you do not need any of the content in the existing
directory and re-create it.
If the
content-repo
directory.
3 Click Start, right-click the My Computer icon, then click Manage.
You can also click Start, then enter
4 Select Disk Management under the Storage section in the left pane.
The disk drive you selected during the beginning of these steps should be displayed in the right
pane.
5 (Conditional) If a driver letter is associated with the partition that you want to use as the new
content repository location, do the following:
5a In the Computer Management dialog box, right-click the drive's partition.
5b Select Change Drive Letter and Paths.
5c Select the drive letter.
5d Click Remove, then click Yes to confirm.
6 Right-click the partition of the disk drive that you want to use as your content repository, then
click Change Driver Letter and Paths.
This is the disk drive that you will mount to the
procedure.
7 Click Add.
This displays the Add Drive Letter or Path dialog box.
8 Select Mount in the Following Empty NTFS Folder, browse for and select the default
directory, then click Next.
content-repo
The default directory is
This mounts the default path to the hard drive partition that you selected previously.
If necessary, format the drive as NTFS using the Computer Management feature in Windows.
9 Click the buttons as necessary to exit and save the configuration change.
10 Copy the files from the old renamed
directory.
From this point on, all ZENworks Configuration Management data is written directly to the new
Content Repository location on the selected hard drive partition.
For Linux servers, you might want the
where the database (if embedded) and content repository are stored.
The minimum disk configuration is required as follows:
Disk Setup for Windows
Table A-2
Partitions Size
Boot (C:) 20 GB
Install (D:) 40 GB and larger
directory is not present in the path given above, create the path and
compmgmt.msc
content-repo
installation_path\zenworks\work\content-repo
content-repo
directory to be located on a large partition. This is
/opt
Contains
Windows System
Installation directory/ZENWORKS
directory, delete the
content-repo
at the Run command line.
directory later in this
directory to the new
content-repo
.
ZENworks Services 97