Configuring The Upgraded Server Packages - Novell PLATESPIN ORCHESTRATE 2.0.2 - UPGARDE GUIDE 10-09-2009 Upgrade Manual

To do this, change to the directory where the current version of PlateSpin Orchestrate was extracted,
then run the following command:
rpm -qa | grep 'novell-zen'
Compare the results of this command with the results you had with the check you performed before
the upgrade (see
page 16). If some of the components have not been upgraded from the earlier version, the
incompatibility between the components could cause unexpected behavior.

2.1.10 Configuring the Upgraded Server Packages

You can use one of two information gathering methods to configure upgraded PlateSpin Orchestrate
packages:
"Running the PlateSpin Orchestrate Product Configuration Script to Configure the Upgraded
Packages" on page 24
"Running the GUI Configuration Wizard to Configure the Upgraded Packages" on page 26
"Manually Configuring the Remote Audit Database after PlateSpin Orchestrate Is Upgraded"
on page 31
Running the PlateSpin Orchestrate Product Configuration Script to Configure the
Upgraded Packages
If you decide to use the product configuration script to configure the upgraded PlateSpin Orchestrate
packages, follow these steps:
1 Make sure you are logged in as
2 Run the script, as follows:
/opt/novell/zenworks/orch/bin/config
When the script runs, the Install or Upgrade option is displayed as follows::
Welcome to PlateSpin Orchestrate.
This program will configure PlateSpin Orchestrate 2.0.2
Select whether this is a new install or an upgrade
i) install
u) upgrade
- - - - - -
Selection [install]:
3 Enter
Depending on which components were installed, the script displays the products to upgrade
Select products to upgrade
#
1)
2)
3)
4)
24 PlateSpin Orchestrate 2.0 Upgrade Guide
Section 2.1.3, "Checking the Current Version of ZENworks Orchestrator," on
to select the option to upgrade to PlateSpin Orchestrate.
u
selected Item
yes PlateSpin Orchestrate Monitoring Service
yes PlateSpin Orchestrate Server
yes PlateSpin Orchestrate Agent
yes PlateSpin Orchestrate VM Builder
to run the configuration script.
root