Removing Obsolete And Unneeded Zenworks Orchestrator Patterns; Revising An Outdated, Required .Conf File - Novell PLATESPIN ORCHESTRATE 2.0.2 - UPGARDE GUIDE 10-09-2009 Upgrade Manual

2.1.6 Removing Obsolete and Unneeded ZENworks
Orchestrator Patterns
After you upgrade ZENworks Orchestrator 1.3 packages to PlateSpin Orchestrate 2.0.2 packages,
you need to manually remove the obsolete patterns and packages that remain after the upgrade.
1 On the machine where the ZENworks Orchestrator 1.3 VM Warehouse is installed, run the
following command:
rug rm -t pattern zw_vm_warehouse -y
A system message is displayed:
The following packages will be removed:
zw_vm_warehouse 1.3-0 (system)
2 Run the following command to remove the remainder of the VM Warehouse component:
rug rm novell-zenworks-vmwarehouse-base novell-zenworks-vmwarehouse-
cimproviders -y
A system message is displayed:
The following packages will be removed:
novell-zenworks-vmwarehouse-base 1.3.0-46 (system)
novell-zenworks-vmwarehouse-cimproviders 1.3.0-27 (system)
3 Because the Monitoring Server in PlateSpin Orchestrate must now be installed on the same
machine with the Orchestrate Server, you need to remove it from its own server and install it on
the Orchestrate Server machine. Run the following command from the command line of the
Monitoring Server machine to stop the monitoring function:
/etc/init.d/novell-gmetad stop
4 Use the following command to remove the Monitoring Server pattern:
rug rm -t pattern zw_mon_server -y
A system message is displayed:
The following packages will be removed:
zw_mon_server 1.3-0 (system)
5 Use the following command to remove the remainder of the Monitoring component on this
machine:
rug rm novell-zenworks-monitor-gmetad novell-zenworks-monitor-web -y
A system message is displayed:
The following packages will be removed:
novell-zenworks-monitor-gmetad 3.0.4-44 (system)
novell-zenworks-monitor-web 3.0.4-44 (system)
Make sure you install the monitoring components on the Orchestrate Server after you have
removed Monitoring from its own machine. For more information, see
Configuration

2.1.7 Revising An Outdated, Required .conf File

After you upgrade from ZENworks Orchestrator 1.3 to PlateSpin Orchestrate 2.0.2, the
auth.conf
installation configuration script ran, is not upgraded.
22 PlateSpin Orchestrate 2.0 Upgrade Guide
Steps" in the PlateSpin Orchestrate 2.0 Installation and Configuration
file (located in the
/etc/apache2/conf.d
"Installation and
directory), created when the original
Guide.
ganglia-