Removing Obsolete Zenworks Orchestrator Patterns; Configuring Upgraded Orchestrate Servers In The High Availability Environment - Novell PLATESPIN ORCHESTRATE 2.0.2 - UPGARDE GUIDE 10-09-2009 Upgrade Manual
Hide thumbs
Also See for PLATESPIN ORCHESTRATE 2.0.2 - UPGARDE GUIDE 10-09-2009:
- Installation and configuration manual (132 pages)
Table of Contents
Advertisement
2.8.4 Removing Obsolete ZENworks Orchestrator Patterns
After you upgrade ZENworks Orchestrator 1.3 packages to PlateSpin Orchestrate 2.0 packages, you
need to remove the obsolete ZENworks Orchestrator 1.3 patterns that are not used in PlateSpin
Orchestrate.
In this example, you need to remove the VM Warehouse and the Monitoring Service from c122. The
Monitoring Service and the Orchestrate Server must be installed on the same machine, so install the
Monitoring Service on c114 and c115.
For more information see
page
22.
2.8.5 Configuring Upgraded Orchestrate Servers in the High
Availability Environment
In a high availability environment, it is necessary to configure only one of the newly upgraded
PlateSpin Orchestrate Servers in the cluster. You should upgrade the machine that was last running
for the purpose upgrading patterns (in this scenario, it will be c114).
1 From the command line of the machine where you last ran commands to upgrade patterns
(c114) run the following command to begin the upgrade configuration:
/opt/novell/zenworks/orch/bin/config
The upgrade script introduction is displayed:
Welcome to PlateSpin Orchestrate.
This program will configure PlateSpin Orchestrate 2.0
Select whether this is a new install or an upgrade
i) install
u) upgrade
- - - - - -
Selection [install]:
2 Enter
to begin the upgrade.
u
The product selection section of the script is displayed:
Select products to upgrade
#
selected
Item
1)
no
PlateSpin Orchestrate Monitoring Service
2)
yes
PlateSpin Orchestrate Server
3)
no
PlateSpin Orchestrate Agent
4)
no
PlateSpin Orchestrate VM Builder (not installed)
Select from the following:
1 - 4)
toggle selection status
a)
all
n)
none
f)
finished making selections
q)
quit -- exit the program
Selection [finish]:
Upgrading ZENworks Orchestrator 1.3 Components to PlateSpin Orchestrate 2.0
"Removing Obsolete and Unneeded ZENworks Orchestrator Patterns" on
51
Advertisement
Table of Contents
