Using The Vt220 Terminal Emulator - Novell LINUX ENTERPRISE SERVER 10 SP3 - ARCHITECTURE-SPECIFIC Supplementary Manual

Example A.7 Parmfile for Installation with NFS, SSH, and HSI and AutoYaST with
ramdisk_size=131072 root=/dev/ram1 ro init=/linuxrc TERM=dumb
AutoYast=nfs://192.168.1.1/autoinst/s390.xml
Hostname=zseries.example.com HostIP=192.168.1.2
Gateway=192.168.1.3 Nameserver=192.168.1.4
InstNetDev=hsi layer2=0
Netmask=255.255.255.128 Broadcast=192.168.1.255
readchannel=0.0.702c writechannel=0.0.702d datachannel=0.0.702e
install=nfs://192.168.1.5/SLES-10-s390x/DVD1/
UseSSH=1 SSHPassword=testing linuxrcstderr=/dev/console
A.3 Using the vt220 Terminal
Recent MicroCode Levels allow the use of an integrated vt220 terminal emulator in
addition to the standard line mode terminal. The vt220 terminal is connected to /dev/
ttyS1. The line mode terminal is connected to /dev/ttyS0. If the vt220 emulation
is available, an icon for an integrated vt220 ASCII console appears next to the icon for
the 3215 console on the HMC/SE.
To activate vt220 support on your machine, edit /etc/inittab as user root. Look
for the following line and delete the leading # sign:
#2:2345:respawn:/sbin/mingetty --noclear /dev/ttyS1 xterm
Save the file and run telinit q to pass the changes in /etc/inittab to init. The
vt220 terminal should then be ready to use. If not, try hitting Enter at the terminal until
the login prompt appears.
Make sure that you do not apply the changes as described above to a system that does
not support vt220 terminal emulators. Otherwise, login might become impossible on
this system and you will be shown the following message:
INIT respawning too fast, disabled for 5 minutes.
To redirect the kernel messages at boot time from the system console to the vt220 ter-
minal, add the following entries to the parameters line in /etc/zipl.conf:
console=ttyS0 console=ttyS1
42 Architecture-Specific Information
NFS
Emulator