Novell LINUX ENTERPRISE SERVER 10 SP3 - ARCHITECTURE-SPECIFIC Supplementary Manual page 50

• Interface hsi for HiperSockets and VM guest LANs:
ReadChannel=0.0.0624
WriteChannel=0.0.0625
DataChannel=0.0.0626
For ReadChannel, enter the appropriate number for the READ channel. For
WriteChannel and DataChannel, enter the WRITE and DATA channel
numbers.
A.2.3 Specifying the Installation Source and
Install=nfs://server/directory/DVD1/
Specify the location of the installation source to use. Possible protocols are nfs,
smb (Samba/CIFS), ftp, and http.
If an ftp or smb URL is given, specify the username and password with the URL.
These parameters are optional and anonymous or guest login is assumed if they
are not given.
Install=ftp://user:password@server/directory/DVD1/
In case of a Samba or CIFS installation, you can also specify the domain that should
be used:
Install=smb://workdomain;user:password@server/directory/DVD1/
UseSSH=1 UseVNC=1 Display_IP=192.168.42.42
Depending on which parameter you give, a remote X server, SSH, or VNC will be
used for installation. UseSSH enables SSH installation, UseVNC starts a VNC
server on the installing machine, and Display_IP causes the installing system
to try to connect to an X server at the given address. Only one of these parameters
should be set at any time.
IMPORTANT: X Authentication Mechanism
The direct installation with the X Window System relies on a primitive au-
thentication mechanism based on hostnames. This mechanism is disabled
40 Architecture-Specific Information
YaST Interface