Novell LINUX ENTERPRISE SERVER 10 SP3 - ARCHITECTURE-SPECIFIC Supplementary Manual page 19

To share a DASD among LPARs, delete the PART=LPAR1 part in the IOCDS definition.
This might be useful for high availability reasons or for sharing data among LPARs
read-only.
Several Linux systems can use the same network device if you share it among LPARs
or z/VM guests. This reduces the number of network devices that must be provided to
the Linux system. On the other hand, you might provide more than one network device
to one Linux system to make it more available in case one connection fails.
Network cards like OSA-Express can be used in two different modes. These modes are
known as QDIO and non-QDIO mode. Define these modes in the IOCDS by using the
TYPE statement. QDIO mode is much faster than non-QDIO mode, but uses three device
addresses instead of two in non-QDIO. Consider the limited number of device addresses
when planning the setup of your IBM System z Linux environment.
Example 1.2 Sharing OSA Express Card among LPARs (non-qdio) on z900
CHPID PATH=(FE),SHARED,PARTITION=((LPAR1,LPAR2)),TYPE=OSE
CNTLUNIT CUNUMBR=FE00,PATH=(FE),UNIT=OSA
IODEVICE ADDRESS=(FE00,016),CUNUMBR=(FE00),UNIT=OSA
IODEVICE ADDRESS=(FE00,016),CUNUMBR=(FE00),UNIT=OSA
IODEVICE ADDRESS=(FEFE,001),CUNUMBR=(FE00),UNIT=OSAD
Example 1.3 Sharing OSA Express Card among LPARs (qdio) on z900
CHPID PATH=(FE),SHARED,PARTITION=((LPAR1,LPAR2)),TYPE=OSD
CNTLUNIT CUNUMBER=FE00,PATH=(FE),UNIT=OSA
IODEVICE ADDRESS=(FE00,016),CUNUMBR=(FE00),UNIT=OSA
IODEVICE ADDRESS=(FEFE,001),CUNUMBR=(FE00),UNIT=OSAD
General Information and Requirements 9