Novell LINUX ENTERPRISE SERVER 10 SP3 - ARCHITECTURE-SPECIFIC Supplementary Manual page 47

Also other linuxrc specific options such as for debugging have to be specified in
the parmfile to be effective.
TIP: Creating a File with Autoinstallation Information
At the very end of the installation of a system you can check Clone This System
for Autoyast. This creates a ready-to-use profile as /root/autoinst.xml
that can be used to create clones of this particular installation. To create an
autoinstallation file from scratch or to edit an existing one, use the YaST module
Autoinstallation. For more information about AutoYaST, refer to Chapter 5,
Automated Installation (↑Installation and Administration).
A.2.2 Configuring the Network Interface
IMPORTANT: Configuring the Network Interface
The settings discussed in this section apply only to the network interface used
during installation. Configure additional network interfaces in the installed
system by following the instructions given in Section "Configuring a Network
Connection Manually" (Chapter 30, Basic Networking, ↑Installation and Admin-
istration).
Hostname=zseries.example.com
Enter the fully qualified hostname.
Domain=example.com
Domain search path for DNS. Allows you to use short host names instead of fully
qualified ones.
HostIP=192.168.1.2
Enter the IP address of the interface to configure.
Gateway=192.168.1.3
Specify the gateway to use.
Nameserver=192.168.1.4
Specify the DNS server in charge.
Appendix 37