Load Standard/Optimized Defaults - JETWAY 845DBA3A User Manual

This section is for setting CPU Frequency/Voltage Control.
CMOS Setup Utility – Copyright(C) 1984-2001 Award Software
CPU Clock Ratio
Auto Detect PCI Clk
Spread Spectrum
** Current Host Clock is 100/33MHz **
HOST/PCI Clock at Next Boot is
** Current DRAM Clock is 133MHz **
DRAM Clock at Next Boot is
PCI Clock Ratio
Vcc1.5 Select
Flash Part Write Protect
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Auto Detect PCI Clk
This item allows you to enable/disable auto detect PCI Clock.
The settings are: Enabled, Disabled.
Spread Spectrum
This item allows you to set the CPU Host/PCI clock and Spread Spectrum.
The settings are: Enabled, Disabled.
Host/PCI Clock at Next Boot
This item allows you to select CPU frequency step by step increasing.
The choice are: 100MHz∼200MHz
DRAM Clock at Next Boot is
This item allows you select the DRAM Clock same as Host clock, or can add 33MHz when
Host Clock under 109MHz.
PCI Clock Ratio
This item allows you to set PCI Clock Ratio. The choice are: Host/3, Host/4, Host/5, Host/6.
Vcc1.5 Select
This item allows you to select 1.5V of the AGP VGA card. The choice are: Default, 1.5V,
1.6V.
Flash Part Write Protect
This item allow you protect your BIOS chip from Virus destroy data. When Flash BIOS you
have Disabled this item.

3-12 Load Standard/Optimized Defaults

Load Standard Defaults
When you press <Enter> on this item, you get confirmation dialog box with a message similar
Miscellaneous Control
X 8
Enabled
Disabled
100/33MHz
133MHz
Host/3
1.5V
Enabled
F6:Optimized Defaults
37
Item Help
Menu Level >
F1:General Help
F7:Standard Defaults