Set Supervisor/User Password - JETWAY 603TCR4A User Manual

3-13 Set Supervisor/User Password

You can set either supervisor or user password, or both of them. The differences are:
Supervisor password: Can enter and change the options of the setup menus.
User password:
ENTER PASSWORD:
Type the password, up to eight characters in length, and press <Enter>. The password
typed now will clear any previously entered password from CMOS memory. You will
be asked to confirm the password. Type the password again and press <Enter>. You
may also press <Esc> to abort the selection and not enter a password.
To disable a password, just press <Enter> when you are prompted to enter the
password. A message will confirm that the password will be disabled. Once the
password is disabled, the system will boot and you can enter Setup freely.
PASSWORD DISABLED.
When a password has been enabled, you will be prompted to enter it every time you try
to enter Setup. This prevents an unauthorized person from changing any part of your
system configuration.
Additionally, when a password is enabled, you can also require the BIOS to request a
password every time your system is rebooted. This would prevent unauthorized use of
your computer.
You determine when the password is required within the BIOS Features Setup Menu
and its Security option. If the Security option is set to "System", the password will be
required both at boot and at entry to Setup. If set to "Setup", prompting only occurs
when trying to enter Setup.
Can only enter but do not have the right to change the options
of the setup menus.
following message will appear at the center of the screen to
assist you in creating a password.
34
When you select this function, the