JETWAY 603TCR4A User Manual page 18

Line-out :
Line-in :
MIC :
Game/MIDI : For joystick or MIDI Device
(8) Serial Port COM1: COM1
COM1 is the 9-pin D-Subminiature mail connector. The On-board serial port can
be disabled through BIOS SETUP. Please refer to Chapter 3 "INTEGRATED
PERIPHERALS SETUP" section for more detail information.
(9) Floppy Drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting
the single plug end to motherboard, connect the two plugs at other end to the
floppy drives.
(10) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s).
If you install two hard disks, you must configure the second drive to Slave mode by
setting its jumpers accordingly. Please refer to the documentation of your hard disk for
the jumper settings.
Audio output to speaker
Audio input to sound chip
Microphone Connector
PS/2
Mouse LAN
PS/2
USB COM1
Keyboard
Floppy Drive Connector
PRINT GAME/MIDI PORT
VGA
Pin 1
15
MIC
LINE-IN
LINE-OUT