Table of Contents
Advertisement
Example:
Using a Pentium
PC-133 SDRAM module, the setting of JPM1 will be all OFF. Will form CPU
BUS CLOCK be 133MHz.
For experience user looking for over clocking, please refer to sec 2-3-4
2-3-3 Install CPU
This motherboard provides a ZIF socket 370.
motherboard should have a cooling FAN attached to prevent overheating. If this is not the
case, then purchase a correct cooling FAN before you turn on your system.
WARNING! Be sure that there is sufficient air circulation across the processor's
heatsink and CPU cooling FAN is working correctly, otherwise it
may cause the processor and motherboard overheat and damage, you
may install an auxiliary cooling FAN, if necessary.
To install a CPU, first turn off your system and remove its cover. Locate the ZIF
socket and open it by first pulling the level sideways away from the socket then
upward to a 90-degree angle. Insert the CPU with the correct orientation as shown
below. The notched corner should point toward the end of the level. Because the CPU
has a corner pin for two of the four corners, the CPU will only fit in the orientation as
shown.
When you put the CPU into the ZIF socket. No forces require to insert of the CPU,
then press the level to locate position slightly without any extra force.
III 866 CPU with front side bus frequency of 133MHz and
Pentium III
Colden Arrow
10
The CPU that comes with the
Intel
CPU ZIF Socket 370
Hide quick links:
Advertisement
Table of Contents
