About The Remote Control; Using A Remote Control; Remote Control; Changing The Signal Code Of A Remote Control - Denon 3800BDCI - DVD Blu-Ray Disc Player Operating Instructions Manual

Introduction
About the Remote Control
I
Using a Remote Control.
Introduction
I
Changing the SigMICode of a Remote Control
I
Loadhlg the ISatteries
CD
Open the battery
compartment cover.
®
Insert two "AA" (R6P)
batteries, with each one
oriented correctly.
Keep in mind the following when using the remote control:
• Make sure that there are no obstacles between the remote
control and infrared sensor window on the unit.
• Remote operation may become unreliable if strong sunlight or
fluorescent light is shining on infrared sensor window of the
unit.
• Remote control for different devices can interfere with each
other. Avoid using remote control for other equipment located
close to the unit.
• Replace the batteries when you notice a fall off in the operating
range of the remote control.
• The maximum operable ranges from the unit are as follows.
- Line of sight: approx. 23 feet (7m)
- Either side of the center: approx. 23 feet (7m) within 30°
-
To avoid the other DENON's BD players responding the remote
signal ofthis unit, you can change the signal code ofthe remote
control. Ifthe signal code ofthe remote control does not match to
the signal code of the unit, you cannot control the unit with the
remote control.
• Change the signal code of the unit
1) In stop mode, press [SETUP].
2) Use [<l/[>]toselectllthen press [ENTER).
3) Use [<ll [>] to select. then press [ENTER].
4) Use [LlI V] to select "Remote Control Setting".
5) Press [ENTER] to select "DENON1" or "DENON2".
I
Setting
this Unit not IleJct
to
Other DENON'
$
OVO Pllyer's
Remote
Control
I
If you have other DENON's DVD players around this unit, this unit
reacts to the commands you made for DVD players through its
remote control. To avoid this situation, you can set this unit not
react to other DENON's DVD player's remote control.
1) In stop mode, press [SETUP].
2) Press [7],[8],[91[2].
3) Press [SETUP].
• "Only Attached Remocon
H
will be displayed on the upper
right corner of the screen and this unit only react to the
commands from this unit's remote control.
• To set back to default, press
[7],[8],[9],[1] at step 2. "Normal
Remocon
H
will be displayed on the upper right corner of the
screen and this unit react to both the commands from this unit's
remote control and the other DENON's DVD players' remote
control.
6) Press [SETUP] to exit.
• At this point the new signal code of the unit is effective. Please
change the signal code of the remote control to match to the
signal code of the unit with following procedure.
• Change the signal code of the remote control
Setto "DENON1":
Press and hold [RETURN], and press [3], [2], [1].
Set to "DENON2":
Press and hold
[RETURN], and press [1], [2], [3].
• If the signal code does not match, the signal code of the remote
control will be displayed on the front panel display.
• The default setting and the setting after you change the
batteries is "DENON1".
00
olio
23 feet (7m) 30·
tal
I 0 0000
00
[~J
23 feet (7m) 30· 23 feet (7m)
@
Close the cover.
6
ENGLISH