Assembling The Reel Stand; Commissioning; Switching The Machine On/Off - Pfaff 1295 Instruction Manual

Installation and commissioning
8

Assembling the reel stand

.01.06
8

Commissioning

.02
8

Switching the machine on/off

.03
8 - 4
Fig. 8 - 06
Check the machine, particularly its electrical wiring and pneumatic tube connections, for
any damage.
Clean the machine thoroughly and afterwards fill it with oil and oil the machine (see
Chapter 10, Care and maintenance).
Have a mechanic check whether the motor of the machine can be used with the
available power supply and that the motor is correctly connected to the junction box. Do
not run the machine if there is any discrepancy.
When the machine is running, the balance wheel must turn towards the operator. If it
does not, have the motor connection changed by a mechanic.
Connect the machine to the compressed air supply. When it is connected, the gauge
should show a pressure of approx. 6 bar. If necessary, have this reading correctly set
(see Chapter 10.06, Checking/adjusting the air pressure).
Switch the machine on/off (see Chapter 7.01, On/off switch).
Carry out a running test.
Assemble the reel stand as shown in
Fig. 8-06.
Afterwards insert the stand in the hole in
the table top and secure it with the nuts
provided.