Table of Contents
Advertisement
Appendix A - Specifications
Physical
Size 130 x 62 x 26 mm (5.1 x 2.4 x 1.0 in).
Operating temperature 0 to 50°C (32 to
122°F).
Built-in cable to the Navman instrument, 1 m
(3.3 ft) long.
Built-in cable to SmartCraft and engine, 300
mm (1 ft) long.
Electrical
Power supply 9.0 to 30 V DC, 50 mA.
Interfaces
NavBus connection to Navman instruments.
CAN bus connection to SmartCraft system.
Standards compliance
EMC compliance
USA (FCC): Part 15 Class B.
Europe (CE): EN50081-1,EN50082-1,
EN55024, EN55022, ISO7637-1.
New Zealand and Australia (C Tick) : AS-NZS
3548.
Appendix B - Troubleshooting
1
No SmartCraft functions available or
SmartCraft data is zero or is not displayed
a
Boat engine key is off.
b
Review installation; check the gateway LEDs
are working (see section 2)
c SmartCraft is disabled in the Navman Instru-
ment. See Setup > System menu.
2
Some SmartCraft data is not available:
The data available depends on engine type
(see section 1-1).
3
Can not start troll control:
a
Some MerCruiser engines do not support troll
control.
b
Set engine to idle and in gear (see section
Troll Control).
Set Speed type to Paddle (see section
c
Troll Control).
d
To use speed troll control, the Navman instru-
36
Cable to Navman instrument
Wire
Red
Black
Brown
Orange
Blue
Green
Yellow
White
ment must have a Navman paddlewheel
speed sensor connected.
4
Trim window is slow to appear, or appears
when trim does not change:
Change the trim filter (see sectionTrim Setup
and Calibration).
NAVMAN
SmartCraft gateways Installation and Operation Manual
Signal
Power positive, 9 to 30 V DC,
50 mA
Power negative
Power positive from instrument
NavBus +
NavBus -
No connection
No connection
No Connection
Hide quick links:
Advertisement
Table of Contents
