NorthStar SMARTCRAFT GATEWAY Manual page 23

Tank Calibration screen will display an amount of
fuel to add to the tank - select OK each time the
measured amount is added. This will happen a
number of times.
i Enter the tank size (volume).
ii Follow the on-screen instructions displayed
to add measured amounts of fuel. Select OK
each time the measured amount is added.
iii The display shows Tank calibration
- Tank profile and asks Is this cor-
rect?.
Select:
OK to accept the calibration
Cancel to cancel.
iv. If the actual tank size did not match that in
step (i), then change the tank size from
the menu.
Reset calibration
Reset the tank calibration to the default - the dis-
played volume is calculated linearly from the sensor
data (see Display type above). Any tank calibration
data will be lost.
SmartCraft gateways Installation and Operation Manual
4-7-2 Trim setup and calibration
Set up and calibrate a SmartCraft trim control (see
section 4-4). Press
displayed, then select SmartCraft, then select
Trim. The options are:
Installed
Select: Trim sensors are installed in the
engine(s).
De-select: No trim sensors installed in the
engine(s).
Trim popup
Select: Trim sensors are installed in the
engine(s).
De-select: Trim popup window is never
displayed.
Trim popup f ilter
This filter can stop the trim popup window ap-
pearing because of engine vibration rather than
a trim change.
Press , then press
value, then press
and 1 to 5.
Select Off or a low value first. Run the boat at a
range of speeds and increase the value if vibration
causes the trim popup window to appear. If the
value is high, the trim window will appear slowly
when trim changes.
Calibrate
Follow the on-screen instructions displayed to cali-
brate the displayed trim angle, and press
as required.
NAVMAN
until the Setup menu is
or to select a
. The values are Off
25