Smartcraft Setup Data And Calibrations - NorthStar SMARTCRAFT GATEWAY Manual

4-6-2 Engine fault history
To display a list of recent engine fault alarms, press
, select SmartCraft, then select En-
gine fault history.
When the Engine fault history is dis-
played
Press or
list.
To display more information about a particu-
lar fault:
i Press or
ii Press
iii Press
list.
To exit the list, press
To clear the engine fault history:
Go to the engine fault history display, press
and select Reset fault his-
tory.

4-7 SmartCraft setup data and calibrations

To go to the SmartCraft setup data and calibrations,
press until the Setup menu is displayed,
then select SmartCraft.
Note:
If there is more than one SmartCraft capable Nav-
man instrument in a system, some setup data may
be different in each instrument.
SmartCraft gateways Installation and Operation Manual
to page up and down the
to select the fault.
to display the information.
or to return to the
.
The setup and calibration options are:
Tanks
Set up and calibrate the tanks (see section 4-7-1).
Troll window
Select from a menu:
On idle: Troll window is displayed when you
press
engine is in gear.
Always: Troll window is displayed when you
press
Never: Troll window never displayed, troll
control is not available.
Troll mode
Select what troll mode controls:
RPM: Controls engine idle RPM.
Speed: Controls engine idle RPM to try to
achieve the desired boat speed.
See section 4-3, notes 1 and 2
Trim
Set up and calibrate the trim display (see section 4-7-2).
NAVMAN
and the throttle is at idle and the
.
23